Do you service Atosa for downtown Walnut Creek kitchens?

Yes. The downtown and Broadway Plaza kitchens run a lot of Atosa prep tables and reach-ins, and we service it as an independent shop, no factory-authorization games. We provide a written repair estimate after the on-site diagnosis and before any work starts. Walnut Creek is a short run up 680.

My Atosa runs on propane refrigerant. Can you fix it?

Yes. R290 is propane, and we're trained and equipped for hydrocarbon work. The sealed system is handled in-house with recovery, evacuation, and a weighed-in charge. Shops that say they can't get parts usually just aren't set up for R290.

How fast can you get to a down Atosa unit?

A failed box in a downtown Walnut Creek kitchen is an emergency. Tell us you're down when you call and we'll prioritize you. We run 7 to 7, seven days, dispatched from San Ramon. The $99 diagnostic is credited toward the repair, with a written quote first.

ATOSA · WALNUT CREEK

Service · All Atosa Models

Atosa Commercial Refrigeration Repair · Walnut Creek, CA

We provide a written repair estimate after the on-site diagnosis and before any work starts.

$99 diagnostic (credited toward the repair)
Same or next-day best effort
CSLB #1136642

Call (925) 999-4095

Atosa in Walnut Creek

Atosa refrigeration in Walnut Creek.

Walnut Creek runs the most restaurant traffic in the Diablo Valley, and that volume lands hard on the equipment. Downtown and the Broadway Plaza side are wall-to-wall full-service kitchens, sushi counters, and gelato shops, and the newer ones lean on Turbo Air and Atosa prep tables. Every venue lives on its reach-ins and prep line working through the lunch and dinner rush, and when an Atosa box quits, food's on the clock. We service Atosa as an independent shop, no dealer claims, no factory-authorization games.

Atosa is the cheap commercial workhorse, sitting under a True on build, so it fails a little earlier, but the failures are predictable: evaporator fan motors seized, condenser coils caked from a busy back-of-house, prep-table thermostats drifting warm, door gaskets torn from a thousand pulls a shift. We stock the truck so most calls involve parts we usually stock, and Walnut Creek is a short run up 680.

Common repairs we do

What we close on the truck.

Prep-table thermostats and coils. Atosa MGF prep tables in the downtown kitchens drift warm when the thermostat quits holding or the condenser coil cakes from a busy back-of-house. We clean the coil, check or replace the thermostat, clear any iced evaporator, and verify the rail temperature across the pans before the compressor runs itself hot.
Reach-in fans and gaskets. The MBF reach-ins die at the evaporator fan motor and door gaskets torn from a thousand pulls a shift. Warm air sneaks past the failed seal and the box ices over. We swap the gasket, clear the evaporator, replace the fan motor from truck stock, and check the seal through its full swing. Two fan-motor sizes ride on the truck.
R290 sealed-system work. A lot of the Atosa and modern reach-ins around town run R290 propane refrigerant, and we're trained on hydrocarbon units for them under EPA #1279674151528. Sealed-system work, recovery, evacuation, and weigh-in, all happen in-house. Central Contra Costa EBMUD water runs moderately hard, so we check any Atosa undercounter ice plate for scale too.

Models we service

Atosa product lines.

MBF reach-in refrigerators and freezers
MGF sandwich and salad prep tables
MWF worktop refrigerators
Undercounter refrigeration
Pizza prep tables
R290 hydrocarbon units

Pricing and warranty

What it costs. What we stand behind.

$99

Diagnostic visit. Credited toward the repair.
Written

1 year parts and labor on the repair, 90 days on consumables. Quoted in writing before work starts.
CSLB

#1136642. Bonded and insured. We file warranty paperwork when applicable.

Nearby cities

Atosa service in neighboring cities.

More cities

Atosa across our service area.

FAQ

Atosa in Walnut Creek questions, answered.

Do you service Atosa for downtown Walnut Creek kitchens?

Yes. The downtown and Broadway Plaza kitchens run a lot of Atosa prep tables and reach-ins, and we service it as an independent shop, no factory-authorization games. We provide a written repair estimate after the on-site diagnosis and before any work starts. Walnut Creek is a short run up 680.
My Atosa runs on propane refrigerant. Can you fix it?

Yes. R290 is propane, and we're trained and equipped for hydrocarbon work. The sealed system is handled in-house with recovery, evacuation, and a weighed-in charge. Shops that say they can't get parts usually just aren't set up for R290.
How fast can you get to a down Atosa unit?

A failed box in a downtown Walnut Creek kitchen is an emergency. Tell us you're down when you call and we'll prioritize you. We run 7 to 7, seven days, dispatched from San Ramon. The $99 diagnostic is credited toward the repair, with a written quote first.

Need Atosa service in Walnut Creek?

Tell us what is broken. We will quote it.